home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Best of Shareware
/
Best of PC Windows Shareware 1.0 - Wayzata Technology (7111) (1993).iso
/
mac
/
DOS
/
CAD_CAM
/
DCAMPLOT
/
DEMOCAM.BAT
< prev
next >
Wrap
DOS Batch File
|
1989-04-26
|
1KB
|
35 lines
ECHO OFF
CLS
ECHO NOTE: YOU MUST SET UP THE RATIO OF MOTOR STEPS TO THE
ECHO WORK TRAVEL WITH DANCAM MENU MODE #5, SO THAT YOUR
ECHO DEVICE WILL MOVE THE PROPER AMOUNT. PRESS [Control] and [C]
ECHO NOW IF YOU NEED TO CONFIGURE DANCAM.
ECHO .
ECHO THIS DEMO OF DANCAM WILL READ AN ASCII DATA FILE MADE
ECHO WITH DANCAD3D v2.x. YOU SHOULD POSITION THE TOOL
ECHO ABOUT 0.950 INCH ABOVE THE MEDIA TO BE WORKED, SINCE THE
ECHO FIRST MOVEMENT IS TO SURFACE A FLAT 1.000 INCH BELOW THE TOOL
ECHO STARTING POINT. FOR THIS DEMO I RECOMMEND USING A TWO FLUTE
ECHO 0.250 INCH DIAMETER END MILL ROTATING AT 4000 RPM. ADJUST THE
ECHO MOTOR STEP DELAY WITH DANCAM MENU MODE #4 TO CONTROL THE FEED
ECHO RATE. WITH 1000 STEPS PER INCH AND 5 MS STEP DELAY YOU WILL
ECHO GET A FEED RATE OF 0.200 INCH PER SECOND OR 12 INCHES PER MINUTE.
ECHO WITH A FEED OF 12 INCHES PER MINUTE AND A 4000 RPM TOOL TAKING 8000
ECHO CUTS PER MINUTE, EACH CUT WILL BE ABOUT 0.0015 INCH, OR ABOUT AS MUCH
ECHO AS YOU CAN SAFELY REMOVE WITHOUT BREAKING THE TOOL CUTTING ALUMINUM.
ECHO IF YOU WANT TO TRY THIS DEMO ON STEEL INCREASE THE STEP DELAY TO 50 MS
ECHO OR CHANGE THE FEED REDUCTION RATIO TO 10000 MOTOR STEPS PER INCH.
ECHO WHEN CUTTING STEEL THE END MILL RPM WILL NEED TO ALSO BE REDUCED TO
ECHO ABOUT 500 TO 1500 RPM DEPENDING ON HOW HARD THE STEEL IS.
ECHO .
ECHO READY 3D 3 AXIS CAM PLOTTER DEVICE FOR DEMO...
PAUSE
DANCAM DANCAM.ASC 1